一方案:
One plan:
準備好緊急驅動軟管,將故障自上料攪拌車熄火,卸下液壓馬達上的高壓油管接頭。
Prepare emergency drive hose, shut down the fault from the feeding mixer, and remove the high pressure oil pipe connector on the hydraulic motor.
將救援車熄火,將其液壓馬達的高壓油管卸下,并與故障車上的對應接頭用緊急驅動軟管相連。
Turn off the rescue vehicle, remove the high-pressure oil pipe of its hydraulic motor, and connect it with the corresponding connector on the failure vehicle with emergency drive hose.
發動救援車,將其操縱手柄撥出料位置,故障自上料攪拌車車內的混凝土即被排出。
Start the rescue vehicle, and turn its control handle to the discharging position. The failure is discharged from the concrete in the loading mixer truck.
緊急驅動完畢后,將驅動軟管卸下,并恢復兩車原狀。
After emergency drive, remove the drive hose and restore the two vehicles to the original condition.
二方案:
Two schemes:
如果上述種方法實行有困難,則采用以下方法,立即排出混凝土。
If the above methods are difficult to implement, the following methods shall be used to discharge the concrete immediately.
在托輪和滾道之間放入木楔,以控制攪拌筒的旋轉,將自上料攪拌車發動機熄火,拆松液壓馬達的一根高壓油管,攪拌筒可自由旋轉,控制攪拌筒的旋轉,使維修孔轉到下部,然后打開維修孔,清理出筒內混凝土。混凝土排出完畢后,恢復混凝土攪拌車原狀。
Put a wooden wedge between the idler and the raceway to control the rotation of the mixing drum. Turn off the engine of the mixer from the feeding mixer, loosen one of the high-pressure oil pipes of the hydraulic motor, and the mixing drum can rotate freely. Control the rotation of the mixing drum, turn the maintenance hole to the lower part, then open the maintenance hole and clean the concrete in the drum. After the concrete is discharged, the concrete mixer shall be restored to its original state.
The above highlights are from: automatic feeding mixer for more wonderful content, please click to enter our website: http://www.ksmayo.cn , we will have more wonderful content waiting for you to check, please continue to pay attention to us.