操作是注意幾個要點
Operation is to pay attention to several key points
1、在混凝土攪拌車作業前需進行檢查，確認轉向、制動、燈光、信號系統靈敏有用，攪拌運輸車滾筒和溜槽無裂紋和嚴重損傷，攪拌葉片磨損在正常范圍內，底盤和副車架之間的U形螺栓連接良好。
1. Before the operation of the concrete mixer truck, it is necessary to check to confirm that the steering, braking, lighting and signal systems are sensitive and useful, the drum and chute of the mixer truck are free of cracks and serious damage, the wear of the mixing blades is within the normal range, and the U-shaped bolts between the chassis and the subframe are well connected.
2、了解施工要求和現場情況。選擇行車路線和停車地點。
2. Understand the construction requirements and site conditions. Select the route and parking place.
3、在社會道路上行駛需遵守交通規則。轉彎半徑應符合使用說明書的要求，時速不大于15km。進站時速不大于5km。
3. Traffic rules shall be observed when driving on social roads. The turning radius shall meet the requirements of the operation manual, and the speed shall not be greater than 15km per hour. The entry speed shall not be greater than 5km per hour.
4、作業時，嚴禁用手觸摸旋轉的滾筒和滾輪。
4. During operation, it is forbidden to touch the rotating drum and roller by hand.
5、在混凝土攪拌車倒車卸料時，需服從指揮，注意周圍人員，發現異常立即停車。
5. When reversing the concrete mixer truck for unloading, obey the command, pay attention to the surrounding personnel, and stop immediately in case of abnormalities.
6、嚴禁在高壓線下進行混凝土攪拌車清洗作業。
6. It is strictly prohibited to clean the concrete mixer truck under the high-voltage line.
6、日常維護
6. Routine maintenance
由于混凝土會在短時間內凝固成硬塊，且對鋼材和油漆有一定的腐蝕性，所以每次使用混凝土貯罐后，洗凈粘附在混凝土貯罐及進出料口上的混凝土是每日維護需認真進行的工作。其中包括：
Since the concrete will solidify into hard blocks in a short time and have a certain corrosivity to steel and paint, cleaning the concrete adhered to the concrete storage tank and the inlet and outlet after each use of the concrete storage tank is a serious work for daily maintenance. These include:
a．每次裝料前用水沖洗進料口，使進料口在裝料時保持濕潤；
a. Wash the inlet with water before loading each time to keep the inlet moist during loading;
b．在裝料的同時向隨車自帶的清洗用水水箱中注滿水；
b. Fill the cleaning water tank with water while loading;
c．裝料后沖洗進料口，洗凈進料口附近殘留的混凝土；
c. Wash the inlet after loading and clean the residual concrete near the inlet;
d．到工地卸料后，沖洗出料槽，然后向混凝土貯罐內加清洗用水30—40 L；在車輛回程時保持混凝土貯罐正向慢速轉動；
d. After unloading at the construction site, wash the discharge tank, and then add 30-40 l of cleaning water to the concrete storage tank; Keep the concrete storage tank rotating forward and slowly when the vehicle returns;
e．下次裝料前切記放掉混凝土貯罐內的污水；
e. Remember to discharge the sewage in the concrete storage tank before the next loading;
f．每天收工時全部清洗混凝土貯罐及進出料口周圍，保證不粘有水泥及混凝土結塊。
f. Clean the concrete storage tank and around the inlet and outlet at the end of each day to ensure that there is no cement and concrete caking.
The wonderful content of this article is provided by the knowledge of automatic feeding mixer. There are many wonderful contents on this website. You can click to enter more contents: http://www.sqjituan.com We have special customer service to answer your questions
山汽微信
2022-12-23
首頁
產品
電話
置頂