久久综合给合久久狠狠狠97色69,国产欧美在线观看不卡,少妇高潮流白浆在线观看,亚洲熟女精品中文字幕

山東山汽工程機械（集團）有限公司
熱線電話：400-879-1999 山汽官方微信
鄭重聲明 購機 售后
在線詢價
熱線電話：400-879-1999
您現在所在的位置: 首頁> 新聞資訊 > 公司新聞

全自動上料攪拌機卸料時應注意的問題

所屬分類：公司新聞 發布時間：2020-06-19 來源：http://www.ksmayo.cn 瀏覽量：0

　　你對自動混凝土攪拌機很熟悉，今天我想跟你解釋一下全自動上料攪拌機卸料時需要注意的問題，希望你在工作時注意。
　　You are very familiar with the automatic concrete mixer. Today, I want to explain to you the problems that need to be paid attention to when unloading the full-automatic loading mixer. I hope you pay attention to them when working.
　　1、進入現場時要盡量走在中間:現場道路簡單，路基松軟，現在攪拌車要做20多輛，靠近路邊時，路面容易被壓碎和塌陷，導致車輛翻倒。
　　1. When entering the site, try to walk in the middle: the road on site is simple and the subgrade is soft. Now there are more than 20 mixers. When approaching the road, the road surface is easy to be crushed and collapsed, resulting in vehicle overturning.
全自動上料攪拌機
　　2,提前下車檢查:混合卡車大多是在夜間,網站,更好是手電筒,下車檢查線,有障礙,坑或更軟的地方,必須記住,滿足鋼釘的時間清理。
　　2. Get off the vehicle for inspection in advance: most of the hybrid trucks are at night, on the website, it's better to use flashlight, get off the vehicle inspection line, there are obstacles, pits or softer places, and it must be remembered to meet the requirements of steel nail cleaning time.
　　3,混凝土罐車必須緩慢倒車時,并不總是把你的頭伸出窗外,看后視鏡的兩邊,如果不確定,停下來看清楚扭轉之前,很多路是挖掘機就軟了,車子很容易下沉。開始,緩慢而均勻的速度開車,扭轉路線盡可能直,如果你想重復下了車,方向盤不殺死或玩,在柔軟的道路容易拖延,節流閥,速度太快,撞上東西。
　　3. When the concrete tank truck has to reverse slowly, it doesn't always put your head out of the window and look at both sides of the rear-view mirror. If you are not sure, stop and see clearly before reversing, many roads are soft with excavators, and the car is easy to sink. At first, drive slowly and evenly, and turn the route as straight as possible. If you want to get off the car repeatedly, the steering wheel will not kill or play. It is easy to delay on the soft road, throttle valve, speed is too fast, and hit things.
　　全自動上料攪拌機卸料時應注意的問題:
　　The problems that should be paid attention to when unloading the full-automatic feeding mixer:
　　1. 在卸料前，讓攪拌槽全速運轉一至兩分鐘，使混凝土充分混合。如有必要，可加水，使混凝土拌合更加均勻，便于排出。
　　1. Before discharging, allow the mixing tank to run at full speed for one to two minutes to fully mix the concrete. If necessary, water can be added to make the concrete mix more even and easy to discharge.
　　2. 卸料時，盡量將車停在地面上，并在卸料前將卸料料斗溜槽弄濕，以便清洗。
　　2. When unloading, park the vehicle on the ground as much as possible, and wet the chute of discharge hopper before unloading, so as to facilitate cleaning.
　　3.喂奶時更好注意自己，不要隨意操作喂奶桿。油箱每次繞中間座轉動時更好停車，以保護減速機和支撐輪。
　　3. It is better to pay attention to yourself when feeding, and do not operate the feeding rod at will. It is better to stop the oil tank every time it rotates around the middle seat to protect the reducer and supporting wheel.
　　4、清洗鍋時一定要仔細沖洗干凈，并將水反復正反轉兩遍，然后放出去，一次要把水箱中的所有水倒入鍋內，然后返回站加水徹底清洗鍋內。
　　4. When cleaning the pot, you must wash it carefully, turn the water forward and backward twice, then put it out, pour all the water in the water tank into the pot for the last time, and then return to the station to add water to clean the pot thoroughly.
　　全自動上料攪拌機卸料時必須注意以上幾點，如果做得不好，可能會造成貯槽封閉的現象。我希望你注意聽了。
　　The above points must be paid attention to when the full-automatic feeding mixer is discharging. If it is not done well, it may cause the phenomenon of tank sealing. I hope you pay attention.

 

首頁 產品 電話 置頂