1、根據減水劑的用量或減水率利用率高的減水劑，選擇適應性好的減水劑和混凝土類型。提高砂石配合比，找到砂石配合比對各砂漿配合比，提高和易性，從而減少用水量。
1. According to the dosage of water reducing agent or the water reducing agent with high water reducing efficiency, the water reducing agent and concrete type with good adaptability shall be selected. Increase the sand and stone mix proportion, find the sand and stone mix proportion of each mortar mix proportion, improve the workability and reduce the water consumption.
2、要嚴格檢驗每種材料的性能，控制以上要素，減少用水量。通過使用大量水泥材料來提高可加工性。多檢查砂石含水量，提高責任心，確保混凝土坍落度在每次出料率的控制范圍內。水泥自上料攪拌機
2. Strictly inspect the performance of each material, control the above factors and reduce water consumption. Improve workability by using a large amount of cement materials. Check the water content of sand and stone more, improve the sense of responsibility, and ensure that the concrete slump is within the control range of each discharge rate. Cement self feeding mixer
3、與水泥自上料攪拌機施工現場施工單位的溝通非常重要。要想得到施工隊的了解，需要配合施工單位方法人員，防止過度坍落度。恰當的概念：并不是坍落度越大，水下混凝土越容易，而是要調整和易性和砂石的用量。這都是非常合理的，并且很可能控制攪拌設備的用水量。大家在實際操作中一定要小心，防止放縱水源。
3. It is very important to communicate with the construction unit at the construction site of the cement self feeding mixer. To get the understanding of the construction team, it is necessary to cooperate with the method personnel of the construction unit to prevent excessive slump. Proper concept: it is not that the greater the slump, the easier the underwater concrete is, but that the workability and the amount of sand and gravel should be adjusted. This is very reasonable, and it is likely to control the water consumption of the mixing equipment. We must be careful in actual operation to prevent the indulgence of water sources.
此外清洗水泥自上料攪拌機的水箱也是不能忽視的，可以這樣做：
In addition, cleaning the water tank of the cement self feeding mixer can not be ignored. This can be done:
裝車后，用清水沖洗進水口，將進水口附近剩余的混凝土清洗干凈，防止運輸后干燥后的混凝土吸附在進水口上。干燥的混凝土不容易清洗。每次運輸混凝土時，進料口都要用水沖洗，以保持裝載的混凝土入口濕潤。在工地卸料后，及時用自帶的清洗水沖洗卸料槽，然后在混凝土儲罐中加入一些清水，保證車輛返回時混凝土儲罐緩慢轉動。
After loading, wash the water inlet with clean water to clean the remaining concrete near the water inlet to prevent the dried concrete from being adsorbed on the water inlet after transportation. Dry concrete is not easy to clean. Each time the concrete is transported, the feed inlet shall be flushed with water to keep the loaded concrete inlet wet. After unloading at the construction site, wash the unloading tank with its own cleaning water in time, and then add some clean water to the concrete storage tank to ensure that the concrete storage tank rotates slowly when the vehicle returns.
及時將水箱內的混凝土殘渣擦干，防止混凝土吸附在水箱內壁上。當它到達攪拌站并重新填充混凝土時，將水箱中的清水排出并重復相同的步驟。將混凝土輸送到罐體和進料口時，避免混凝土吸附；裝砼時，不要偷懶，將隨車自帶的洗車水箱灌滿洗車水不加水。
Wipe the concrete residue in the water tank in time to prevent the concrete from being adsorbed on the inner wall of the water tank. When it arrives at the mixing plant and refills the concrete, first drain the clean water from the water tank and repeat the same steps. When the concrete is transported to the tank body and feed inlet, avoid the adsorption of concrete; When loading concrete, do not be lazy. Fill the car washing water tank with car washing water instead of adding water.
The above is the full-automatic feeding mixer http://www.ksmayo.cn// Thank you for checking the information of our company in your busy schedule. If you want to know more, you are welcome to call us for consultation!
山汽微信
2022-12-23
首頁
產品
電話
置頂