自動上料攪拌機使用小知識
Tips on the use of automatic feeding mixer
攪拌車在出現故障的時候,需要及時將內部的混凝土清理出來,通常有兩種方法清理:
When the mixer truck breaks down, it is necessary to clean the internal concrete in time. There are usually two methods to clean it:
方法一:
Method 1:
1.準備好緊急驅動軟管,將攪拌車熄火,卸下液壓馬達上的高壓油管接頭。
1. Prepare the emergency drive hose, turn off the mixer, and remove the high-pressure oil pipe connector on the hydraulic motor.
2.將救援車熄火,將其液壓馬達的高壓油管卸下,并與故障車上的對應接頭用緊急驅動軟管相連。
2. Turn off the rescue vehicle, remove the high-pressure oil pipe of its hydraulic motor and connect it with the corresponding connector on the faulty vehicle with emergency drive hose.
3.發動救援車,將其操縱手柄撥出料位置,故障車內的混凝土即被排出。
3. Start the rescue vehicle, turn its control handle to the discharge position, and the concrete in the faulty vehicle will be discharged.
4.緊急驅動完畢后,將驅動軟管卸下,并恢復兩車原狀。
4. After the emergency drive, remove the drive hose and restore the two vehicles to their original state.
方法二:
Method 2:
在托輪和滾道之間放入木楔,以控制攪拌筒的旋轉,一定要注意;將發動機熄火,拆松液壓馬達的一根高壓油管,攪拌筒可自由旋轉,控制攪拌筒的旋轉,使維修孔轉到下部,然后打開維修孔,清理出筒內混凝土。此時一定要注意,混凝土排出完畢后,恢復攪拌車原狀。在一般情況下,多數人會選擇用方法一來,當方法一不了時才會選擇方法二。
Put a wooden wedge between the supporting wheel and the raceway to control the rotation of the mixing drum. Be sure to pay attention to it; Turn off the engine, remove a high-pressure oil pipe of the hydraulic motor, the mixing drum can rotate freely, control the rotation of the mixing drum, turn the maintenance hole to the lower part, and then open the maintenance hole to clean the concrete in the drum. At this time, it must be noted that after the concrete is discharged, the mixer truck shall be restored to its original state. In general, most people will choose method one to solve it, and only choose method two when method one can't solve it.
混凝土攪拌車怎么區分:12方,14方,之類的,還有作為新手,應該注意哪些?
How to distinguish between concrete mixer trucks: 12 square, 14 square, and so on. What should I pay attention to as a novice?
1.一般12方及其以下方量的一般都是用6*4車型或者是說6*4長的軸距 14方及其以上方量的要8X4或者是說8*4的底盤。
1. Generally, the chassis of 12 square meters and below is generally 6 * 4 model or 6 * 4 long wheelbase, and that of 14 square meters and above is 8x4 or 8 * 4 chassis.
2.攪拌車有高低檔,新手掛檔要注意。
2. The mixer truck has high and low gears, and novices should pay attention to gear.
3.車輛轉彎重車不要超過30碼??哲囎约赫莆铡?/div>
3. When the vehicle turns, the heavy vehicle shall not exceed 30 yards. The empty car is under your control.
4.倒車要注意,遇到不是熟悉的工地一定要下車看清楚路況。
4. Be careful when backing up. You must get off the car to see the road conditions when you encounter an unfamiliar construction site.
特別是灌樁發熱:
In particular, cast-in-place pile heating:
1.油泵吸油口的過濾網是否堵塞了,拆出濾網清洗一下,再試試追問剛換的柱塞 泵和馬達全大修的。
1. Check whether the filter screen at the oil suction port of the oil pump is blocked, remove the filter screen and clean it, and then try to ask about the overhaul of the plunger pump and motor just replaced.
2.在裝管的時候,密封性是有沒有裝好,有沒有可能漏氣 。
2. When installing the pipe, whether the sealing is well installed and whether there is possible air leakage.
3.檢測壓力是否正常 。
3. Check whether the pressure is normal.
4.檢查連軸器是否出現發熱。
4. Check whether the coupling is heated.
This article is provided by the automatic feeding mixer. Our website is: http://www.ksmayo.cn/ We will serve you with wholehearted enthusiasm. Welcome to visit!
相關 / NEWS RECOMMEND ATIONS