1.每天收工時徹底清洗混凝土貯罐及進出料口周圍自動,自動上料攪拌車的清洗要點保證不粘有水泥及混凝土結塊;
1. At the end of each day, thoroughly clean the concrete storage tank and the area around the inlet and outlet. The cleaning points of the automatic feeding mixer should ensure that there is no cement and concrete caking;
2.每次裝料前用水沖洗進料口,使進料口在裝料時保持濕潤;
2. Flush the inlet with water before each loading to keep the inlet moist during loading;
3.在裝料的同時向隨車自帶的清洗用水水箱中注滿水;
3. At the same time of loading, fill the cleaning water tank with water;
4.裝料后沖洗進料口,洗凈進料口附近殘留的混凝土;
4. Wash the inlet after loading and clean the residual concrete near the inlet;
5.到工地卸料后,沖洗出料槽,然后向混凝土貯罐內加清洗用水30—40 L;在車輛回程時保持混凝土貯罐正向慢速轉動;
5. After unloading at the construction site, wash the discharge chute, and then add 30-40 l of cleaning water to the concrete storage tank; keep the concrete storage tank moving forward and slowly when the vehicle returns;
6.下次裝料前切記放掉混凝土貯罐內的污水。
6. Remember to discharge the sewage in the concrete storage tank before the next loading.
7.攪拌車進料口給料量是否合理:正確的方式是物料在吸料口和空氣形成一定的氣物混合比,在氣流的推動下均勻流入上料機。這個時候我們需要將料槍設計帶有補氣功能。如果物料積壓時間過長可能很硬,這個時候需要在料槍上裝一個振蕩器,敲碎結塊的物料。
7. Whether the feeding amount at the feeding port of the mixer is reasonable: the correct way is to form a certain gas-solid mixture ratio between the material at the suction port and the air, and flow into the feeder evenly under the push of the air flow. At this time, we need to design the material gun with air supply function. If the material overstocking time is too long, it may be very hard. At this time, an oscillator needs to be installed on the material gun to break the caked material.
Today is Xiaobian's introduction to the automatic feeding mixer. Please pay more attention to our website: http://www.ksmayo.cn We will update the follow-up content regularly!